CPU Peak only Report in SCOM2012R2

Forum: Operations Manager4

Tagged: , ,

Viewing 4 posts - 1 through 4 (of 4 total)
  • #229850
    Profile photo of Dominic
    Dominic
    Participant

    Hi,

    I have been asked to produce a report with information and graphs for only peak CPU Usage. Servers are all 2012R2. I did have a ¬†good look in Scom but couldn’t find anything except the Performance Detail which gives all 3 values?

    #229851
    Profile photo of Wilson W.
    Wilson W.
    Participant

    If you are creating a performance detail report how are you getting 3 values unless you specified 3 values? -Sounds like you are using a pre-canned report.

    Just create a performance detail report showing processor information….% Processor Time only.

    #229864
    Profile photo of Dominic
    Dominic
    Participant

    Im not sure I explained it right , I have attached the report example. I meant that I get min max standard deviation etc – I don’t have a rule called % Processor time only either?

    Attachments:
    You must be logged in to view attached files.
    #229873
    Profile photo of Wilson W.
    Wilson W.
    Participant

    I’m not sure I’m following you. In your initial post you said you were trying to create a report showing peak cpu usage. In your screenshot you have min/max info in there so that is your peak usage right there. SCOM aggregates values on an hourly basis. The hourly performance detail info can be displayed by expanding the table below the graph.

Viewing 4 posts - 1 through 4 (of 4 total)

You must be logged in to reply to this topic.